Audi Q3 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hi, just did a few mods to my MY16 Q3 and now my front turn signals are flashing between blinks as though the voltages are messed up, almost like the HZ of the refresh rate of a monitor was messed up. This happened somewhere after changing something. Only really removed the DRL's shut off with blinkers - but changed it back and still have problems, and changed the rear fails to separate the turn signal/brake light... Also changed that back and still have the issue... It's random but clears the codes and it still comes back. Any ideas?
 

·
Premium Member
Joined
·
2,484 Posts
First, welcome to the forum - hope you come back and find other good stuff for yourself. As for your issue, I hope you did a backup scan clean BEFORE you started any code changes. I would that over VERY closely - my guess you've changed something you didn't intend to and changing just what you think you changed back is NOT fixing the unintentional changes. You can just copy the longcoding of your backup text string and paste it into the longcoding to redo it.
 

·
Registered
Joined
·
3 Posts
Discussion Starter #3
Well the only thing I can think of, outside of the obvious things I know I changed, specing the headlights as halogens with ROW LED tail lights for the separate brake/turn signals is the only thing I can think could've affected it because I've got a MY16 with LED headlights.... So if so, I did change that back and it got rid of it but is there another code specific to the 16 and the LED headlights? Or should that not have affected it?
 
1 - 3 of 3 Posts
Top