Audi Q3 Forum banner

Enable Gauge Pointer/Needle Sweep

10015 Views 4 Replies 3 Participants Last post by  guille
Enable Gauge Pointer/Needle Sweep on Start :

[17 - Instruments]
[Adaptation] >> "Staging" Channel
Set to "Active"
Go Back/Exit
  • Like
Reactions: 1
1 - 5 of 5 Posts
I tried this but I received a out of range error
When you say test does that mean start the vehicle?
I will try this mod in the next weeks that I have time, I hope to work
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.