Audi Q3 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1
I finally got decent enough weather to tackle this project, this was motivated by rock chips taking a toll on the lower valance on my Q3 and me looking to build a bit of a unicorn US Q3.

Things to note;
-Audi literature says not for US model but of course it went right on
-Audi literature says not for S-Line and it is a direct swap for S-Line, in fact the parts art tagged S-Line from the factory
-Audi literature says front mudflats are not compatible with offload package and of course they are
 

Attachments

·
Registered
Joined
·
17 Posts
Nice, that looks awesome! Was it difficult to do? Where did you find the parts?
 

·
Registered
Joined
·
28 Posts
Discussion Starter #3
The rear valance was fairly easy as well as the wheel arch moldings. Door moldings we not difficult but time consuming to get the adhesive to separate without damaging paint. Removing the front bumper is easy but taking it apart to replace the air vents and spoiler required removal of close to 20’screws and a lot of patience. I did this solo and it took about 7 hours, with a second person knock a few hours off.

I got the part numbers off the Audi accessories page in Germany and then referenced them with Audi.7zap
 
1 - 5 of 5 Posts
Top